View Full Version : MEGAsquirt
- Where to buy 4N25 optoiso in NOVA!?!?!?!
- question about my MSQ
- IAT sensor failing?
- Spark and fuel map for 1.6 RC440's. Please. I'm finnally finished!!!!!!!!!!!!!!!!!
- Finally dead set on goin MS, a little help please...
- ms-pnp weird inj behavior
- Take a look at my board. Help me sort and prep my MS.
- Megatune Colors
- MPG gauge in MT
- New .Inc for Wideband
- Haltech Map
- Coolant Problem W/ GM Sensor
- URGENT Need help, no RPM input!
- pre-dyno tuning / minimizing dyno time and ching-dow
- can someone make one of those cap boxes for COPS?
- megasquirt wont turn on all of a sudden?
- Want to log higher than 215*F?
- I'm Squirting! - MS2Extra 2.0 '91 Miata
- Escort GT TPS outputs
- I'm Squirting! 2000SE Parallel Install
- Dies on a hot start
- Basic EBC Questions
- 94-95 1.8L no tach signal
- Megasquirt S-video to dsub pin out
- auto tps
- Intermittent puff sound
- Basic data needed (PW, input type etc)
- IAC settings for a 99 motor
- Woohoo launch control actually works.
- The Most Standalone MS2 99' NB Ever (And A Couple Questions)
- MS EBC is awesome
- How the hell do I get the ECU out on my 2000 Miata!
- Everything but time, direction and a little Braineak help!-Planning My MS install
- Misfire like hell
- 10g questions
- no tach 1.6 MS 2.2
- Will resets effect VE analyzer?
- Calling all input circuit genius type people
- MS2 power
- Parallel Harness help!
- MS 2.2 spark mods....
- baro correction and MLV VE analyizer
- Shaping the boost curve AKA EBC solenoid tuning
- MS + stock ECU; anybody else done it this way?
- high map reading at idle, very slight IAC noise
- Overboost protection not...protecting
- MegaSquirt with old TechEdge DIY
- Rev Limiter doesn't seem to work
- My Megasquirt thinks its a pipe organ
- EDIS4 On A 99' FTMFW
- MS says my clt operating temp is around 215*F
- Idle tuning megathread (let's sort our idles out together)
- 1.6 FP relay circuit
- Barometric Correction (turn it off?)
- how do I get megatunix to run on windows
- I got boost! and some questions.
- TPS Signal
- closed loop boost control aka Boost kpa targets
- Unplug Ignitors
- Did I fry megasquirt?
- Can a miata run on two cylinders? COP problems
- Boomslang Build Question Afterthoughts
- Quick question about Gair
- Easy peasy pins for wiring harness
- Info/instructions for Wells TPS201 TPS ** PICTURES!
- ok megasquirt dummy
- MSPNP base map. Map showing low ambient kPa. WTF?
- It's been done before but I felt like sharing
- FIDLE mod flyback diode
- If you run an MSPNP 94/95 or 96/97 please read this
- Doesn't need rehasing, BUT...
- Just a Test - Attaching MSQ and Log
- IAT/CLT Based Timing Advance & Retard
- It runs, but only on cyl 1 and 3? any ideas?
- My MS died
- Follow up on 2-toothed nb crank trigger
- MS Ground Wire Question
- Tach shows up in megatune, not on gauge cluster
- Dyno later today - Suggestions!!!???
- Are all meqasquerts the same?
- GM IAT connector...how to assemble?
- 97 fan control
- Easy, dumb question about Hi-Res
- hope i didn't blow something, ignition problem
- AFR Targets in Megatune
- NB MS2: CMP, CKP, WTF? (more TLAs inside)
- Acceleration Wizard settings
- Still getting resets
- Hey you! Come analyze my fuel map.
- Woot! running MegaTunix on my eeePC
- Idle bounces... Boing, Boing, Boing
- First it worked, now it doesn't
- Installed HR code
- Cranking/Prime table
- 9697 MSPNP- lean after restart
- MS dwell settings for COPs
- GM Open Element IAT Sensor part number
- What is port a port b & port c in MLV?
- I put the MS in MSM.
- Used MS PnP initial install
- Stim Build almost done! Pics!
- Serial to USB from ebay
- Nor Cal Tunning?
- MS timing
- MSPNP cutting out fuel at various loads
- Upgrading oem pump.
- Is there a thread or location posting MSQ files?
- Anti Rev System (Traction Control) ????
- Idle valve frequency settings???
- Stock post-cat bung ok for WBO2 (I don't have a cat) ?
- MegaTune loses connection while loading .msq to MSPNP
- Another LC-1 Related question; Settings:
- Megasquirt PCB assembly
- Resistance on Q14
- Help an idiot convert to wideband
- Will my MS be erased if I have the battery off for about a week?
- Strange Rev Limit problem-fixed (changed spark plugs)
- Faulty MAP sensor?
- no clt gauge...
- Revving on its own.
- Yet more EeePC awesomeness
- VE analyzer can't nail it & AFRs jumping around
- Problems with 90-93 MSPnP
- Q about MLV and AFR target tables.
- Anyone know where i can find a "64 Pin Male connector (174518-7)" in stock?
- To boomslang or not?
- MAPdot accel affecting AFR at steady throttle
- 330's + FPR
- Hi Res and Palmlog?
- My first log after plugging in MSPnP
- Which of these is the right tach driver circuit for a 96
- Solder onto Boomslang Connector Pins
- Flex Fuel with MegaSquirt Controller
- Paranoid! ! Plus my MS is not working
- MSD Ignition box?
- Easytherm, MSPNP, firmware Q's
- How to Connect
- Weird IAT issue after reflash (MSPNP)
- Help, my MS won't talk!
- MSPNP Hi-Res setup questions
- MLV AFR target table problem
- Tuning Table Size VE and Advance POLL inside
- ms signal
- Where can I download the MS tuning manual?
- Bad idle after long drive
- Lumpy idle.
- Going to the Gap, should I be worried about altitude?
- Where to start with MS and a sr20det engine
- I think i have a faulty injector circuit in my MS
- LC-1 Bouncy
- Need help - VE Analyze/MLV
- Ahhh, squirtin'! Got some ?s
- Help im terrible with electronics
- My latest project...
- How do YOU tune?
- tried to install megasquirt, now won't run on stock ecu
- 1.6L to 1.8L Conversion... What Throttle Body???
- 550cc installed and barely made it home.
- EBC Issue
- tps
- I think MS hates me
- MS 1.8L BEGI S3 map request
- Will the MS not run without an O2 sensor?
- overboost not working
- Megasquirt on a 99 (work safe again.)
- What to do with Idle Control Valve?
- DIY MS Running in germany, but I´m confused
- Just a quick question.
- Can I see your boost duty table pretty please.
- Finished my MSI V3.0 build and tried to start up = no luck after 4 hours.
- Launch Control FTMFW
- Lost my speedo after modding and reflashing!?
- What the back of the 1.6 head is supposed to look like.
- Failed firmware upload with MSPNP?
- Take a look at my plugs. (running rich)
- Coolant sensor craziness!
- 23mpg
- Part # for IAT sensor for MSPNP
- What does EGO correction use for its target?
- More MS questions, need help
- Hi-Res code = ohmymotherfuckinggodamazing
- Electronic 'detonation cans'
- NB IAC Settings?
- Fresh Build, no CLT reading
- MT RPM Gauge not reading but VE Table tracks RPM
- Did someone ever figure out the CLT resistance data for 96-97 cars?
- Cruise goes way lean
- Prebuilt MS?
- Newbie question using LC-1
- Too many advices on tuning VE?
- I am building a MS board now and have a question
- Tell me what this means.
- Ignore my 4-1 wheel post...
- Retune after minor intake/head work?
- MSPNP Launch control problem.
- tunerstudio ms
- Megasquirt Spark timing maps?
- Air Conditioning switch no longer works, megasquirt PNP?
- Megasquirt PNP Launch control problem, need help!
- Megasquirt Rebooting under Boost
- where can i buy the oem ECU harness connector
- Trying to spool faster. Peek at your spark maps?
- Timing Issues
- Too rich, plugged cat
- PNP Harness for MS VII?
- cylinders 2 and 4 running rich :confused:
- AIT and CLT temps seem to be off
- Run w/ Disconnected O2?
- Cruise too lean?
- 1st Datalog
- Pins Stuck!
- Help with MegaLogViewer
- dissconnecting controller
- no fuel from injectors 2 & 4
- MSPNP - Grounding Issues
- Boomslang Parts Group Buy from Onlinecomponents.com
- Anyone gone from 93 to 91? (octane)
- building a boomslang - questions...
- COPs with MS2
- Alternator Control box for standalone MS install for NB
- hmmz.. dunno if I trust my WB anymore.
- MS timing
- 1990 mx5, 550 injectors, T28
- I'm building a stand alone MS and have a couple of questions
- mspnp9697 knock after install?
- Power line weirdness = dead MS
- Problem while upgrading to 'No AFM'
- 97 turbo ms1ns issues
- Anyone using megatunix?
- MSPNP9093 with a 1.8 swap
- Impossible to program LM Programmer (?)
- Another full standalone nb....
- How might one go re scaling the kpa table in MLV
- How do I set up a shift light on my 96-97 Megasquirt PNP
- NB Megasquirt Owners questions...
- Just ordered mspnp
- how does this spool look?
- Banking Injectors?
- MSPNP Boost Controll Issue.
- Mspnp9093 Major Problemssssss!!!!!!!!!!!!!!!!!!!help
- MS pnp vs a kit
- Did I set base timing correctly?
- Any AE tuning tips from you gurus?
- weird problem with launch control
- lower temps leaning out my fueling?
- Stupid Plug locating
- Megasquirting my stock '99 NB
- It says controller code version does not match signature MSnS-extr.ini.
- No RPM Signal In MT
- errors on 3.0v w pnp map