View Full Version : MEGAsquirt
- Spark mod changes on DIY's Site
- Braineack - Read and respond to your PMs!!!
- Standalone 1.6 Wiring Diagram / Schematic
- Cam gear tuning + excessively retarded timing
- mspnp vtps mod
- MS1 help needed
- Stim boots ECU, car doesn't
- stock gauge cluster
- 64 pin ECU connectors
- Good news - MS2 closed loop boost control
- Garbage boomslang connectors
- for the 99 guys running ms1
- sustained misfire @ high boost
- OK. I'm a retard!! What on MS did I fry?
- flip switch for different fuel map?
- simple tach question
- MAP signal to connect WI to?
- Miatamoxie's MS Standalone Install
- Problems
- Kit verses PnP; are they really different?
- Help me get this car running.
- Warm start problem
- HELP! On the side of the interstate right now!
- Tuning KnocksenseMS
- Tach signal WTF.
- Troubleshoot Timing Issues - MSII
- idle gayness v.confusion
- Rich on tip in...
- Pop on startup (and not what you think).
- MAP signal problems
- tps
- Two seperate quick questions...
- Closed Loop Boost Control
- new MS1 install, coils sploded
- Charging issue with NB alternator control.
- Woo Hoo Motherfuckers!
- Megatunix with Ubuntu 8.10
- 2001 ls...MS?
- All MS users, chime in!
- MS1 V3 Full Standalone on 1990 B6ze
- No spark again.
- MS1 intermittantly not working w/stim
- 64 bit Vista compatible US-serial adapter?
- Newbie Question: EBC
- Strange IAT problem
- I need help with tuning!!!
- Voltage too low to burn changes
- help with mspnp9093 fan control
- Really odd cold related problem
- Tuned ...shut off the car and wont start
- About to order an MSII, need some input.
- EBC clicking
- Car not starting ('00 MS1 standalone)
- How do i enable 12x12 tables?
- I want to hire somone to set up my launch control.
- ECU plug?
- Need more...AEM/MT readings off (search didn't fix it) & Cold Cranking/Start Issue
- Troubleshoot Jumpy RPMs - MSII
- No connection between MS and laptop
- Cold star issue, won't start.
- LC1 & DB gauge ground wire ... 16ga ok ?
- Last issue with MS. Lean spike on closed throttle.
- noob about to order it all
- MS2 standalone on a 1990
- I'm RICH! and paying for it. (failed testing)
- Please help with Tuning!
- Stuck on Highway!!! Help!
- Need Advice with Low-Z RC550cc Injectors
- Setting timing in MS problems.
- Megasquirt help in north Atlanta, GA this weekend
- Won't Start! (better than before)
- where to buy miata ecu 64-pin connector?
- MS Reset craziness!! HELP
- KPA is off in MT...not sure what MM means.
- Using AFR instead of Volts with AEM Wideband in AFR Target Table
- EBC is useless!
- Real Time Injector Pulse Conversion? (and other bits of fun)
- '95 N/A MS2 starter msq?
- TPS and Coolant Set Up
- Getting Started With Begi-S tune
- No RPM signal in MT. MS1V3 and Megastim assembly question
- Anyone in VA willing to try my Megasquirt?
- Ms ebc ????????
- Won't start
- Error while trying to edit settings
- Where do I install the knock sensor?
- Quick Help? Low Vac/Idle issues on install, no A/F readings
- Third week of MS troubleshooting
- Voltage Spikes In Datalogs? (help!)
- Purge solenoid with MS
- Is it OK to run 30 gauge wire...
- What happens when the limits of an MS table are exceeded?
- who's using AEM uego?
- Easytherm values for 99 parallel
- Stumbling idle on cold start.
- NA Miata Won’t Start With MS1
- Anyone have a Jim Stim I can borrow?
- A couple quick questions.
- LC1 power supply question
- firmware issue ?
- mspnp+aem uego = BAH
- MS installed, no start
- MS wired up, what recommendations are next?
- How do I post my msq?
- Notice anything weird about this ve table?
- Megasquirt PCB question
- Help me work out this MS-II please
- IAC, PWM, idle thingy verification
- building a ms similar to mspnp
- Light throttle surgeing and leaning
- idle kpa?
- quick question ( newb ) on megasquirt install
- Map Request
- Standalone MS and factory immobilizer 99+ ?
- MS2 boost control settings
- question about linear tps and boost duty table
- How many I/O?
- M.S Virgin modifying a 2nd hand MS 1v3
- Bouncy AFR at low throttle - why
- car cranks, no tach signal on Megatune
- Megatune error when trying to connect
- It's Alive (Sort Of)
- Which size line for GM boost solenoid?
- Tuning Spark
- Running open-loop at all times. ok or bad idea?
- what parts do i no longer need?
- MS with 360cc injectors what level of boost?
- Tuning Fuel Economy
- 10G link?
- MSPNP and 99 Head question
- Braineak PnP install questions...+AEM/MS questions
- NA car, WOT, how lean is OK
- EGO correction for track only car?
- MAP sensor off T-fitting from FPR ?
- Discussion On Ignition Timing
- how can I make my mspnp9093 idle without the idle control valve?
- Plug gap and MS resets
- Been out of the game for a year, gimme a little help :)
- Help us test something out here
- MS1 3.57 upgrade to MS2 - questions/help
- jeez how do I get this!! (launch control q)
- MS1 V3 Assembly Issue/Question
- DIY Base MSQ into HR?
- Turbo Installed - Post Test Drive Questions/Problems
- I think my MEGASQUIRT is Dead!
- 2nd attempt at MSing, still problems.
- *MORE* LC-1 Problems
- What happened to the GPIO?
- First Winter with 550's cranking
- Please peruse my datalogs
- Another Megasquirted '99
- Flashed HR10G to MSPNP, small issue with misfires
- 64 pin connector for a NB
- Tuning with Fiance's laptop
- Anyone have an .msq file I can use to get me going on my turbo?
- 1.8 swap w/ 90-93 mspnp
- Another MSPNP and LC-1 troubleshoot thread
- MT Boost Gauge
- MS not starting car...
- Fuel leans out when outside temps drop.
- MS + Uego on N/A NA
- Idle control issues can someone sanity check my .msq?
- POP when turning ignition on (not cranking) and burned fuel smell
- Where can I buy the 64 pin ecu connector?
- How to set up Launch Control on MS?
- Help with Accel Enrich
- Running out of time, can someone look at my log?
- MS finally ordered
- Before and after dyno runs (NA 1.6L car)
- MS build thread - for a 99 but 1,6 (Euro) MX-5
- WIdeband or not for MSPNP??
- EasyTherm 5.0
- I'm fast and (mostly) smooth now!
- Coil arcing w/o engine running
- Igniter and coil wiring to MS confusion
- Warning to other newbies: baro correction and lumpy idle
- EBC Rules... and loves to stay 100% duty 100% of the time :p
- afterstart IAC question
- Which 0.1µF ?
- My fan mod is mocking me
- Missing Parts
- More MS problems...
- Ignitor plug, which one is it?
- Megatune issues
- CAS wiring...
- Bias for 91 CLT/IAT and Temp Resistance Pairs
- High-Res Fresh Install
- problem again.. need good msq.
- MSnS and OBD2
- Starting settings for AE
- Tuner in Miami
- 91 N/A IAT Questions - Parallel Install
- More Acceleration enrichments
- Acceleration enrichments - I want to eat my cake too
- EBC data log and duty target tune help
- Abe & JasonC's NB Cam & Crank input circuits
- MS-II 3.0 vs MS-II 3.57
- AEM WBO2 troubleshooting tips?
- Hooked up the stim
- Where to place AIT relative to WI?
- 99 1,6 MS1 - First startup - no start, no rpm 90-97 CAS
- looking for easytherm files
- Another Cooling Fan Activation Issue!
- Finally got a MS, have wiring questions
- Using crimp connectors in wiring O.K.?
- MSNSPNP: 94 S/C Miata reset issue?
- Megatune isn't reading my wideband AFR correctly after hi res
- Clutch switch ECU pin on 99
- MS1 flashing firmware
- Problems connecting to my MS
- Connect GM IAT with AFM in place
- MS1 vs MS2 for a NA
- Final Check and Parallel Harness Construction
- a few more MS/LC1 questions.
- Problem with MS PnP 90/93
- Megasquirt And Flipouts.
- I'm confused about injector banking, timing....oh and alternating injection
- Auto 1.6l Thottle body with VTPS install (PICs)
- O2 Correction at Idle or something?
- Installing the megasquirt on a stock car
- 0.1uF cap mod on MSPNP
- How to do the grounds on db37
- Megasquirting my stock '99 NB - the initial install
- msq for 2.3L Ford?
- No problems forever until now... warmup enrichment
- MSQ and datalog review
- MLV 2.95 upgrade, settings lost
- Sanity check...why so lean
- Brainack MS is Baller!! Thanks so much!
- Cooling Fan Activation Issues!
- Set timing on a 99 with 90-97 CAS
- Move IAT sensor to Intake manifold?
- Not running right
- Error while testing during build.
- Big box of headache delivered to the door...
- M.s 3.57
- MS PNP on a MG
- MLV Tables to rich
- help, weird cold issues
- Ugh, no IAT and someone is coming to help tune..
- Controlling VVT
- lc-1/MSpnp super lean
- Coolant Corrected Air Density & Hot IAT Idle
- Base map required
- MS 1 with stock sensors??
- world's dumbest MT question
- IAC help
- Connect Megasquirt / Megasquirt PNP to dataloggers
- wanna run my 550's but..
- Spark Mod and Boomslang Question