View Full Version : MEGAsquirt
- tuner cable broken. help!
- A/C Idle Up
- baro correction issues
- MS serial to OBD2 connection
- 1994 MS1 going into a late 1995
- Jason's proposed closed loop boost control strategy
- Greddy Kit baseline Tune MSII V3
- Is this normal AFR behaviour?
- Latest gslender mod posted v2.7
- Proper timing and EGT at cruise
- Motor blew up, check out my tune.
- Review my Tune
- Car is tuned, dyno sheet
- PnP 01-05 MS3 + MS3X
- Looking for some base msq's for my how-to's
- VVT with MS3: Need some maps
- MegaSquirt and the shift light
- Reverant MS2 "switch between VE/Ignition tables"?
- Car is idling, what's next?
- How Much for MS PNP 1st Gen?
- MTX-L or LC-1 Is one better ( or worse )
- MS3x A/C Jumper - Please verify
- MS3x installed, tach doesn't work.
- MS2 1.8 Starts, Runs, Revs. What do I do from here? Wont idle. Runs Lean.
- MTX-L GND or SG?
- Megasquirt in... car won't start. Help.
- MS1v3 - JS4-JS5 signal leak. How did I screw things up?
- wiring in launch control to my home built MS1v3.0
- How do you run your vacuum lines?
- Hydra to MS2v3
- Quick stupid question. Does PNP run closed loop?
- 1.6 OEM ecu timing map?
- NB 1.8 idle, basic setting help
- Toyota Cops MS Misfire problem
- I need some MS help
- Enhanced MSII, flashing CEL
- 1990 w/1.8 swap just installed MTX-L
- Confused on IAT
- MS1 1.6 to BP-Z3
- bluetooth to megasquirt settings
- I'm getting closer, starts and idles pretty well, wont drive
- MS2 fan control
- Fuel table question (high load low kpa)
- First autotune- Input appreciated
- Dashpot decay factor? Can't find info the manual
- Is there no cool down fan setting?
- Mspnp2, loaded tune, tuner "cant handle" bricked
- Help me get my LC-1 to match TS A/F
- Revs horrible, runs great wtf
- Smoothing VE tables - Interpolation Spreadsheet
- '99-'00 Miata test mule needed for MSPNPs
- no engine braking?
- Retune boost PID after turbo swap?
- idle issues with A/C
- tuner studio errors on netbook
- How to convert MS2 to stand alone
- blew highside driver no st sign.
- Can my mspnp control water/meth?
- Budget MS build questions.
- no power until 5200rpm
- Boost target table - how does yours look...?
- Critique my tune
- DIYPNP Coolant Temp Problem
- MS1 losing CAS signal
- Weird alternator circuit issue
- Ms1 v3.57 has no tach imput,ms shows that there is no rpm but all other sensors work
- Need help finalizing my MS2 jumper harness.
- Cutting power to the Megasquirt
- Megasquirt on ebay?
- Light throttle stalling/stumbling
- Extreme hesitation under load
- Noob tuning troubles
- Critique my tune please :)
- stalling and VE table question
- MS3 no start, have spark, fuel, not sure about timing
- 1997 tps to MS1 w/relay board question
- Reverant MS unit - no tach / rpm
- Microsquirt help.
- Strange Boost control / AFR problem
- Need help, freshly built DIYPNP crank but no fire (edit : Working now!)
- DIY PNP Wideband Voltage issue.
- Question(s) for those logging EGT with MegaSquirt
- N00b Needs AFR help...
- fuel pump realy problems 92 mspnp
- Can't lower idle, Help
- Issues under load. Diagnose my log!
- Base map 00 miata id1000cc injectors?
- MAP problem?
- DIYPNP deleting 1.6L CAS
- rpm gauge oscillate after ms 2 installation
- MS3 knock module updates
- MS1: idle after hot restart fixed!
- Why is my afr steady sometimes and unsteady at others?
- Idle Help
- Spike in VEtable at ~5000rpm 10Psi - normal? Fuel pump?
- 99-00 DIYPNP box. Thing to do before plugging it in? Megatune question?
- Does this look right to you? Fuel table
- MSpnp no power
- 99 DIYPNP - Starting Failure
- Who does MS tuning in NJ/NY area
- DIYPNP TPS Calibration Problems
- Cooling fan always on? Wtf?
- DIYPNP DB15 Connections
- MS3+MS3x, 99-00 loosing sync at 4500rpm - SOLVED!
- AFR spikes lean - mild misfire?
- GM IAT installed, but now car wont start
- Looking for MS1 Settings for 36-1 Trigger
- 5ms dwell at idle, 3ms above 2k
- No fast idle on 90-93 MSI
- Can't rev over 6k
- DIYPNP Spark advance basemap for boost
- MS for 1.6. What version do I have?
- 99 shanghai cutting out above 4k
- Where can I find MS2 with afm basemap?
- My Megasquirt plans check and feedback pls.
- Accel Enrichment / Stall issues (90-93 DIYPnP)
- Using EasyTherm5 with the hr_10g
- DIYPNP MS1 and the fuel pump
- Ms3 MS3x on a MSM
- 2000 Miata MS question
- mspnp connection issues
- lost sync 31 & 32
- MS3X users - go to 1.1.1
- Got the car to start... but sounds like it's not running on all cylinders
- Cylinder 2 Plug Shows Hot
- Changing injectors and ve table?
- Looking for help
- Map sensor reading high at idle
- Should my temperatures be spiking like this when I dont have my DIYPNP hooked up?
- Wtf did I do? I reconnected the connector in front I throttle body. Car won't start.
- MPX4250AP or MapDaddy?
- MS3, MS3x, 1ZZ COP, Sequential Fuel and Spark
- Not pulling over 6000rpm
- Another connecting problem
- 99 miata need some help.
- Can someone take a look at these msq?
- Car cuts at high boost.
- First Drive With MS3, Tune/Turbo Trouble
- 460cc RX-7 injectors dead time
- Trigger offset angle issues
- ms3/x loses power when injector fuse is pulled
- MS + Injector wiring
- Stock ECU VE table
- AEM UEGO 6 in 1 = AEM Linear AEM-30-42xx
- MS1 to MS3, no spark
- What is this stumble?
- DIYPNP - Starts but can't idle 93 Miata
- Idle viiiiiibration!
- Mspnp, 10g hi-res, tooth & trigger problems
- some wire identification need to get the mega squirt sparking
- regular AE or accel pump style AE?
- gen2
- Updating firmware
- cant get a spark with my mega squirt help
- MS2 and LS2 coils
- How would you ste these injectors up?
- Upgrade MS1 to MS2 CPU
- registering tuner studio
- Street Tuning on a Narrowband and a sanity check
- When do you go open loop? Plus VEAL questions
- stock bp timing map
- Stock base map.
- gslender v22b2 issues!
- DIYPNP - Cannot calibrate TPS
- Noob question: MSPNP for 1.8 on a 1.6?
- MSPNP2 install... noob edition
- Confirmation: DB37 pin/ harness wire orientation (spark issues) -MS1e/1997
- MS2 squeal on startup
- NA to Boosted Megasquirt Settings
- Can I run with a bad o2 sensor tomorrow?
- Does MS and a RR-FPR play well together?
- Started my MS3X build this week, questions to follow
- MS Rpm Drop issue
- change AFR to lambda
- ITT: MS3X VVT settings and tuning
- Can Megasquirt run two separate sets of injectors?
- Help me fix my fail. VE tables and AFR target tables. MSPNP MM9495 w/maf
- Updating firmware in-situ: safe practice
- Easytherm Settings
- Are my coolant temps normal (MS3/X)?
- Where to ground WB for 99 MS install ASAP
- MS-II connection issue
- Crazy Map reading. Help!!
- diypnp looses signal at above 3/4 throttle.
- Setting base timing in a '99
- Is my MS1e soldering/set-up correct?
- Need idiots guide to installing MS in a '99
- How hard is to to go Megasquirt?
- Ignition Fail on Dyno!!! Help Please.
- please hold my hand.. afr target
- new computer, fresh install, MegaTune comm problem
- 99 Miata turbo not starting
- Timing Light Recommendation?
- Erratic AFR / Mapdot, Noise issue?
- Dyno sheet Rotrex 15-60 SC & MS DIYPNP tables
- mspnp95 base timing set, idle still bad, change fuel table?
- Tunerstudio autotune without wideband?
- Interesting news about noise on TPS MS V3 board
- Upgraded to MS3X. Losing sync on cranking
- MAF data
- Knock control on the MS2
- Idle fuel setting wants to be really rich
- WHY NO REVLIMITER??? because r@$3(@! but srsly 8500+lol...
- Picked up two MS Units, what mods have been done?
- AFR's changing, no changes to fuel map
- 1.6 to 1.8 swap
- TS and MLV licenses
- Parts needed to upgrade MS1 to MS3x?
- MS3X full PnP, build me one.
- General MS help please
- Idling's a BRAINY
- Cold start - have to push throttle a bit to start - what MSQ change?
- Fried my MSPNP tonight... Can it be fixed??
- Check my MSQ (no start)
- MS-1 Idle Issues
- 1.6 fuel pump mod /***fixed-bad new tip125***
- Tuning suggestions for idle VE table
- Pre Built MS3/ MS3x; wiring and general questions
- cant get a stable timing indication
- hot lean restarts
- Boost, Stumbling, No Power
- Check my Tables Please
- 5psi actuator hitting 10psi-GREDDY
- MS2 settings help
- A Couple Quick Questions Before I build my DIYPNP
- MS3, Turbo, and Timing
- Wild Idle After Sequential Upgrade
- MS3 idle voltage correction
- SOLVED: Idle Valve Gone Wild!
- So let's pretend I did something dumb and changed my idle screw.
- Turbo install, wont start now
- MS2 - how do i reduce my idle rpm
- Two timing marks 01+ engine
- diypnp base map?
- Probably a stupid question
- VEAL pulling to much fuel?
- Ms2 diy maps?
- Another aem wideband reading off from tunerstudio
- Unstable TPS signal, Brain MS2, so cannot setup boost control.
- negative trigger angle?
- Cam and crank sensor setup with VVt
- Buying Used MS3
- MSPNP test cars we're looking for
- MS Wont Start (Pics Inside)
- DIYPNP, falls on its face between gears, what to adjust first?
- Not a question, But a Megasquirt Tuning Experience...
- Megasquirt Startup Settings
- Big noob cant get car started with MS2
- How to rewire to get sequential fuel injection??
- MS2 goes lean on acceleration