View Full Version : MEGAsquirt
- Engine misses at idle and at light load when hot, AFR seems unstable
- I²C RTC DS13072Z
- High AFR on basemap MSPNP MM9093
- Warm Up Enrichment Auto Tune?
- Hard starting in cold weather on E85
- Adding VDO sensors to MS3 and sharing with gauge?
- A summary of the Megasquirt family for newcomers
- MSPNP map sensor help
- New to Miata's
- MS3X Shopping list for a 2003
- TS indicator output channel help.
- On the subject of Winter Gas
- Connection Woes on new Megasquirt
- ID1000 data for Megasquirt from Injector Dynamics
- MS2 Enhanced Knock Control - help in setting up.
- What happened to Frank's Ms3x guides!?
- Could use help troubleshooting - Misfiring at 6200 RPM on a friend's 240sx
- MSPNP1 wiring issue
- What 4 Bar MAP Sensor for MS3 PRO?
- Need More Analog Inputs - MS3PRO
- Need help with alternator circuit Franks MS3pro adapter
- Enhanced MS2 and Sequential Injection
- Table switching with AC idle up, DIYPNP ms2extra 3.3.2
- no spark on 1 and 3 log attached
- MS2 Cam posistion signal help!!!
- MS1 Extra idle oscillation
- New Rev Basic MS3 in a stock '99 - won't start
- Who uses the Boost by gear feature and how...
- VTPS fuel cut setting in TunerStudio?
- MS3+MS3x Lost Fan Control
- First and (sometimes) second pull super lean. No enchriments. NB1.
- '99 DIYPNP CL Idle Issues
- Diypnp firmware issues
- Trigger Angle Offset Q
- MX5 Mk2 Hot engine Idle erratic.
- MS3x Nitrous In and JP8 question
- Idle advance numbers.
- Finally got a MS3x
- configuring '99 standalone MS2 for '94
- a few faults
- MegaSquirtPNP G2 MM9697 on a 97 uk spec 1.6
- Toyota cop conflicting ports
- jumpstart/ smoking MS3X
- cant connect to tunerstudio :/
- MS3X IAC1A as boost control
- MS2 + VVTuner + NA = Sync Loss
- Logging pulls in Tunerstudio (Setup AutoLogging)
- Ground came disconnected, now I'm a rotary
- 2014 MegaSquirt meet at DIYAutoTune.com HQ - Sept. 20
- **Not miata*** KA24DE help
- NB Miata, Need to set base timing?
- Need MS3 Tuning Help; Backfiring
- MS3X and OEM NB2 knock sensors?
- Lean out on idle.
- MS1v3.0 launch control inop
- mspnp2 v1.2 launch
- MS3: Noisy TPS Signal
- Using additional inputs on DIYPNP
- Temp and TPS issues amongst other things
- MS2DIY or DIYPNP
- Easy way to scale tables?
- MS2 Basic, Dropped revs and lean spike when throttle from idle.
- Problems with MTX-L Accuracy (Complicated)
- MAT/CLT Correction table
- Why does my MAP decline slightly over WOT pull?
- N/A AFR tables
- Microsquirt install wiring question
- swapped back to stock ecu and no car sounds like its running on 2 cylinders
- DIYPNP - No Spark Suddenly
- VVTuner into 96 MSPNP - inconsistent RPM while cranking
- Mspnp gen1 resets in full throttle/boost
- Struggle to crank
- DIYPNP, Idle Droop w/ Headlights
- Restart drops AFRs a point
- MS2 Timing at idle lower than map
- Insanely high MAT's
- Rough idle and lean
- Basic MS3 No start
- Quick Question on spark output
- FAB9 COP & MS3 basic. Any issues before I order?
- Brain built MS3x, which output is for CEL?
- Perceived Megasquirt problems?
- boost table /MAC Vavle 04 MSM
- Stock vs Mega: Lean off-throttle
- sequential injection schematic help!
- Multi purpose led output
- Base timing and AFR issues, new MS3x
- Non-linear injectors.
- MS3 Datalog Retrieval Speed, Up to 4X Faster
- Anyone running supermiata damper, 36-1 on 01+ head with MS3 ?
- Build Extension harness from wreck?
- NB1 Alternator Control Circuit, BOM
- Looking for tuner/shop in NJ
- MSPNP Pro - now ready to ship!
- Ms1 help
- NB1 DIYPNP Startup Logs and .msq, What next?
- MegaSquirtPNP Pro MSM0405 users/owners
- When Wideband is Heating up, how does MS calculate AFR?
- 99-00 Ms2 start up problems.
- '92 ECU opinions
- Trouble getting car to start on diypnp
- Simplest way to eliminate CAS in VVT swap?
- Innovate MTX-L and MS2 rev built .....
- NB1 with vvt ms3 basic, no start no run (Need Help Plz)
- Not sure if misfiring under load or something else...
- Anyone heard of "THE DUB SHOP" in washington?
- Enhanced MS2 drivability issues: Stalling, Hunting Idle, Poor Throttle Response
- Revs up to 5000 rpm when I crank up?!?
- Turbo 1.6 MSPNP + COP = No Spark
- Finished DIYPNP for NB1, have questions about startup map.
- Help locating Firmware for 3.0.3h startup map?
- R14 DIYPNP
- MS3 EBC Issues
- Rev built MS2 baro correction not working
- Miata specific thermistor and other setup information?
- COPS - Dwell Setting, location..Please Confirm
- intermittent ignition cut at 6k...
- HELP - crank but no start
- MS1 won't stay running
- SyTy stumbles through learning to tune
- Pops and Bangs on initial startup
- Basemap question
- Slightly confused, DIYPNP I/O Clarification Please
- Does anyone offer a E-Tune service for MSPNP 2nd Gens?
- Megastim for DIYPNP?
- MS3-Basic FW Upgrade Issues
- MS3 V1->V3 Upgrade - No RPM Sync
- Feeler: MSPNP-Pro based plug & play for NA or NB1
- MSPNP-Pro: PNP Standalone for 2001-2005 and MSM
- 36-2 with vvt - fumbling
- Low MAP kPa @ key on/engine off and Full throttle. stumped!!
- Idle tuning tips
- Anyone hear from Rev lately?
- Blower speed and AC switch input
- DIYPNP 1991 No Start
- Rev MS3 basic Issue with EBC closed loop
- Microsquirt/MS2 for 99/00?
- 36-1 trigger question
- Changing back to the MX5 original ECU
- 1v difference between Pin 28 and indicated voltage?
- My MS3X is draining the battery
- cylinder 2 & 4 rich/missfire
- Cam sensor and 4 wire tps connectors
- Microsquirt questions
- Advice / protips on maps
- frank's board in a Rev built MS2 +
- Let's discuss AFR safety system
- 3.3.2 Table Switching MS2e question
- Some Help in Understanding Different Megasquirts
- Diypnp problem loading firmware
- 90 miata ms3 installed, now no tach
- Making 10FT cable-cable boomslang - does the 64p connector exist?
- '03 COP Settings - DIYPNP - Car Is Barely Drivable
- switching an "idiot light"??
- Anyone in SE MI install MS3?
- No tach in 94 1.8 MX-5 with MS3X
- MS3 basic knock control
- Megasquirt "Resetting" Causing Tune Issues
- Car will not "cold" start
- DIY PNP or other...
- TROUBLe getting idle to work even in PWM warmup
- DIYPNP no start problem.
- Very lean on hot restarts
- Rev built MS3 basic afr problems
- MS3 not getting power
- Some analysis please - MK1 1.6 Turbo
- Reverants new MS2 unit with serial port and older MS2 with mini usb
- Roadster turbo with reverant basic ms2 needs help
- Tachometer not working
- Very short lean spikes on throttle
- DIYPNP - 00 to 03 VVT Tune Changes
- MX5 Turbo 1990 MS1 Lean AFR (Air leak???)
- New MS3 owner at a loss, please help.
- AFR0 at startup and MAT calibration weirdness
- MS3X 100% idle duty cycle
- A/C not working, did I fry something?
- DIYPNP - Why no PA0 available in output ports in TS?
- VEAL custom filters
- MTX-L gauge vs TS AFR
- MS3 Basic Tomfoolery
- MSPNP: Taking car for tuning, any specific areas to address?
- MS3 Basic burble-pop on lift
- Updating tune to current firmware
- sounds like 2 cylinders
- Please help me understand why VEAL won't make changes
- Megasquirt 5K rpm issue
- Odd findings with AEM wideband o2 (35-8460)
- MS2 Flooding Engine on cold start
- Check Engine Light Settings
- CLT Monitoring, getting warm/cooling off fast?
- Check engine light on Reverant-built MS2
- Need help! No fuel on 1&3
- MS2e Thermistor Calibration
- 1990 1.6 ms3x no start
- '99 DIYPNP - DB9 Power, Bluetooth Connection, and EBC
- engine running. where to get base maps
- MAC valves extremely noisy
- how does my tune and datalog look?
- Intake air temperature compensation?
- Megasquirt and EBC, I hate it
- I might have fried my sensor.
- +++Somewhat URGENT+++ Switching to MS2, 36-2 Timing Wheel on a 1996 Car
- Ignition map
- Cant get MS2 running, please help
- Running rich when hot - MAT correction?
- NA 94 MS3(3.57)+MS3x no start - help please
- NA alternator swap issues
- What is the deal with my funky VE map?
- MS almost built, testing a DIY PNP?
- ITBs realtime barometric correction
- No voltage to IAC Valve
- Converting Megasquirt to miata
- Reverant MS2e 2002 Connector - COP sequential wiring
- IAC Stuck open @ 102 steps
- MPG- give me some input please
- My tunerstudioms has a mind of its own!
- a question of timing
- MAT correction issue - leaning out on hot starts
- HELP car will not run when warm. DIYPNP
- Help diagnose no start, please
- 3.31 firmware and AC not working Solution
- Onboard usb connector for MS2!
- MapDaddy vs. GM sensor
- Track day in 10 days, supermiata damper 36-1 in car or ...
- Stalling with ms2
- NEED HELP with TPS not working.
- MS3x Fuel cut when IdlePWM > 38%?
- MS3x losing sync only while cranking
- Bypass MS for AC
- A/F gauge reading different than MS3.
- Help me with Microsquirt (ms2) willing to pay via paypal.
- MegaSquirt 2 V3 Board, D1 & D2 Jumper?
- Injector Wiring for batch fire
- Help me get my car started with a MS3x on my 97, please!
- '91 Diypnp Tach output for cluster - IGN-1A coils
- timing stuck on fixed - help
- Error after COP install
- AFR's Still Not Right
- MS EBC Duty Cycle question
- Mad props to whoever can explain this to me...
- Normally Aspirated NA8 and GM AIT
- Tuning boost control on the MS3x
- IGN-1A Ignition coils, Diypnp '92 1.6 spark help
- Megasquirt wiring help Please!!! 04 MSM
- Upgraded ms1 to ms3 couple questions
- Cl boost target table
- 100 hours, still slightly worse than a stock ecu.
- MS2 no spark, but D14+16 light up
- MS2E, Added Turbo, Idle very erratic
- pulling power for my MS1 off of the back of the alternator. good or bad?